|
|
|
|
 Back up light switch
#1103738
08/14/17 06:43 PM
|
Joined: Sep 2005
Posts: 118
OP
Wheeler
|
While searching around for what was blowing my dash fuse I found that the back up light switch(?) wire had broken off and was rubbing on the drive shaft. It was just two bare wires and I can tell the switch is missing its wire connections. Any body have a part number and what is missing after being ground off by the driveshaft, will I have to make my own male connector? I tried to post a photo but would not up load. The broken switch is on the passenger side of the manual trans.
'91 montero a/t cranked t-bars 31x10.5x15 212k
'90 toyota extra cab 320k v6 5 speed 31's 4x4
'99 expedition 17" alloys v-8 207k 4x4
'88 BMW 325iX 247k AWD
'59 Willys Jeep Koenig PTO winch and hardtop 28k
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 3.916s Queries: 15 (3.913s) Memory: 0.5950 MB (Peak: 0.6280 MB) Data Comp: Off Server Time: 2026-10-22 15:47:40 UTCValid HTML 5 and Valid CSS 
