<strong>Are there installation kits available? Are the 5.38's dimensions compatabile with stock 4.56 and a kit for that set can be used? </strong>
Well, an install kit consists of pinion shims, carrier shims, crush sleeve/pinion preload shims, marking compound, pinion nut and sometimes new bearings/ring gear bolts. None of this stuff should be effected by the Tera 5.38s as where all these pieces ride is unaltered... so yes, a 4.56 install kit would work just fine, in fact, any install kit for an Isuzu 10-bolt (someone correct me if i'm wrong here).

<strong>Another shop had a concern about the carrier... if Tera had compendsated for the size... <img border="0" title="" alt="[Confused]" src="images/icons/confused.gif" /> </strong>
yes, the stock carrier is what these gears were designed to fit.

Good luck with the install. Make sure to report back to us <img border="0" title="" alt="[Big Grin]" src="images/icons/grin.gif" />

-Rob

<small>[ December 05, 2002, 06:37 PM: Message edited by: RobG ]</small>


Robert Gorrell
1995.5 Isuzu Rodeo - SAS'd and SOA'd, sitting on 38x13 TSLs, spooled D60 front, 14bff rear locked by detriot, high steer w/ hydro, dual Isuzu tcases.