</font><blockquote><font size="1" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">quote:</font><hr /><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">Originally posted by MontyPower:
<strong>Give us some help regarding installing the manual hubs... Any tricks? Hints? How long did it take?</strong></font><hr /></blockquote><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">Be sure ahead of time that you have the right size of allen wrenches. 1/8" for the little ones (talking about Superwinch hubs), 8mm for the big ones. Do NOT use a 3mm wrench on the little ones, or you'll tear out the screw head...don't ask how I know. 3.5mm is too large...1/8" is just right. On the big bolts, tap the 8mm wrench into them with a hammer until they bottom out to make sure you have full contact or, again, you'll chew the bolthead out. I used an 8mm allen socket with a largish ratchet and an extension.

Be sure you have C-clip pliers handy. It'd be hard to get that clip off otherwise.

Have a pot or tube of axle grease handy to replenish what you wipe out.

Took me an hour on the first one, well under 30 minutes on the second. The time on the first one was involved in carefully taking everything apart so I knew where it went, as I'd not had it apart before. The second one went MUCH quicker.

You don't have to jack anything up or remove the wheel. Doing this in the parking lot of the part store is quite feasible.

<small>[ February 08, 2003, 07:53 AM: Message edited by: AcidophilusRex ]</small>