|
|
|
|
 A/T Temp Sensor
#200263
02/24/03 07:53 PM
|
Joined: Apr 2002
Posts: 28
OP
Getting the Wheeling Fever
|
I need to replace the A/T temp sensor, and I was wondering where one could be obtained at the best price? Is this a stealership only part? Additionally, are there any concerns or tricks to replacing this? Thanks!
1991 3.0 Montero...
<small>[ February 24, 2003, 03:18 PM: Message edited by: toyota87 ]</small>
1987 Toyota 4x4 Long Bed Deluxe
|
|
|
Re: A/T Temp Sensor
#200264
02/24/03 10:53 PM
|
Joined: Jan 2001
Posts: 13,649
Web Wheeler
|
You could just ground the wire, because the "sensor" is just a normally closed temp switch that opens and breaks the od switch ground circuit when the engine heat gets above the trip limit. Nothing special on the removal or install, except use thread sealer and don't take the tapered threads too tight.
Not responsible for advice not taken...
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.006s Queries: 14 (0.004s) Memory: 0.5868 MB (Peak: 0.6350 MB) Data Comp: Off Server Time: 2026-06-24 20:46:50 UTCValid HTML 5 and Valid CSS 
