i run 33x12.50 Super Swamper TSL bias ply on 10" wheels and have only trashed one cv axle in the past several months of hard wheeling, but keep in mind i trashed that cv at the same time i trashed my t-case and a rear u-joint due to some serious wheel spin on a uphill climb/bounce/landing/ouch!

recently i cranked my torsion bars down enough to lower my front end an inch, which helps with the cv axle angle ... this was possible due to the change in suspension geometry when i had my rear leaf spring over done, which actually raised the front an inch ... now my torsion bars are not at max crank, which is good ... i also went back to using high-profile lower bump stops up front because the 33s were rubbing up in the wheel wells too much

<small>[ July 02, 2003, 11:05 AM: Message edited by: Selimyar ]</small>


had an '88 Montero, then an '04 Rubicon ... sold 'em tho