</font><blockquote><font size="1" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">quote:</font><hr /><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">Originally posted by Selimyar:
<strong>recently i cranked my torsion bars down enough to lower my front end an inch, which helps with the cv axle angle ... this was possible due to the change in suspension geometry when i had my rear leaf spring over done, which actually raised the front an inch ... now my torsion bars are not at max crank, which is good ... i also went back to using high-profile lower bump stops up front because the 33s were rubbing up in the wheel wells too much</strong></font><hr /></blockquote><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">That's funny Ray. I just lowered my t-bars an inch the other day too. The a-arms were always bottoming out, and the ride was way too hard. How much did you gain in the front by lifting the back?

PHIL


1991 HZJ77, 1999 KZJ90, 1999 UZJ100, 1992 M101CDN2
https://www.thegearheadproject.com/category/jdm-journeys/