I put 32 SSRs on this spring with 2 inch leaves in the rear and the torsion bars (Rancho) raised about 1.5 up front. The rims are 3.75 bs. I still had to remove about an inch of the front fender up to the arch, cut the fenderliner back and pounded the seam flat. I threw away the mudflaps when I still had 31s. I had rub until I started cutting.

IMHO, if you get to cutting, use a jigsaw with a high tpi metal blade. Mask the fender where the foot of the saw will run. Much easier to control and a cleaner cut than you'll get with a sawzall.

~Adam


96 T100: D44, lockers and stuff