|
|
|
|
 coil spring spacers
#234713
06/05/03 06:05 PM
|
Joined: Jun 2003
Posts: 140
OP
Wheeler
|
I am wanting to make my own coil spring spacer and was wondering if any one else has tried this. I am going to use Tuff Country 3" add-a-leafs in the rear and the spacers in the front. By the way i have a 98 Tacoma.
My signature has been removed.
|
|
|
Re: coil spring spacers
#234714
06/06/03 05:54 AM
|
Joined: Jul 2002
Posts: 1,592
Toyota Moderator
|
You know, I have never seen a drawing for them, but it can't be too difficult. I think if you do the machining, you will come out ahead. But if you have to pay someone, I think the Cornfeds will be cheaper.
Wheeling a Stepside Tacoma on 37s
Exploring in a T4R Ltd V8
|
|
|
Re: coil spring spacers
#234715
06/11/03 06:11 PM
|
Joined: Jun 2003
Posts: 140
OP
Wheeler
|
I have done some searching on the net and found a site that sells the spacers. It shows a close up pic and they looh east to make. Looks like you could cut two peices of place out the same size as your mounts and weld one on each side of a peice of pipe and just make it the size you want. With the center cut out for the shock of course. I would post the web site but i am not sure on you rules. The cornfeds do have some good prices, i think i will get my diff drop from them.
My signature has been removed.
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.008s Queries: 13 (0.006s) Memory: 0.5911 MB (Peak: 0.6435 MB) Data Comp: Off Server Time: 2026-11-01 19:42:28 UTCValid HTML 5 and Valid CSS 