<strong>What are you guys using for front driveshaft donors? </strong>
I started out with the stock driveshaft, just lengthed and ground yokes. Then changed to a 6" bronco slip running a Toyota 41* joint at the tcase end. Now, I'm running a square tube draftshaft I built for the extra slip (6" wasn't enough for the flex) with that same Toyota joint at the end.
<strong>I think that the waggys use 1310's on their pinion yokes, but I don't know what sort arrangement the Zu Tcase has coming off the front. </strong>
Yea, thats correct. 1310 is at the tcase end as well, however the tcase uses a flange rather than a yoke. The flange will accept 1310 i believe and is a custom bolt pattern, so changing that out is difficult... I had a new flange custom made with the Isuzu pattern to accept the toyota joint.
<strong> I suspect I'll need to get whatever driveline I get cut down, but I'd rather not screw with combo joints etc.</strong>
Yea, I'd be surprised if you didn't. Just stick with 1310s at both ends. The stock driveshaft lengthed makes a good starting point, grind the yokes for some more angle, and its got like 3-4" of slip. Otherwise, square tube is nice and easy to do, loads of slip, but not to be used above 5-10mph (very shakey).
<strong>, I'd assume a ~40" front driveshaft?</strong>
40"? wow. your setup is a lot different than mine. I dream of 40"! My shaft is like half that, 20". given i have a manual and you'll pick up a few more inches with the auto, but unless you moved that axle really far forward, i don't think its gonna be that long.
-Rob
Robert Gorrell
1995.5 Isuzu Rodeo - SAS'd and SOA'd, sitting on 38x13 TSLs, spooled D60 front, 14bff rear locked by detriot, high steer w/ hydro, dual Isuzu tcases.