Eureka!

I've been driving around the last few months always wondering just how much gas I really had in my tank because of a faulty fuel gauge. I had priced a new fuel sending unit (gauge and pump) from the dealer at $318 and a salvaged one at $127. I couldn't locate just the fuel gauge element itself. I didn't want to buy a used assembly because I was afraid I'd have the same problem again in a short time with a used one.

Sunday I dropped my empty fuel tank and pulled out the assembly. After closely inspecting the fuel gauge element I determined the spring steel wiper assembly had worn out and was not making contact with the resistive circuit board.

This assembly is a simple device that utilizes a float, linkage and a wiper circuit board component. The wiper has two arms that wipe across two foil strips on the circuit board. It was the spring steel wipers that had worn out and no longer made contact with the circuit board foil.

I disassembled the unit and carefully reshaped and bent the spring steel wiper to establish good contact again. After putting it all back together and adding 6 gallons of gas, I turned the ignition switch on and waited a little while for the averaging circuit to compute the new level and Eureka! It works! It registered a little above a 1/4 tank. <img border="0" title="" alt="[Big Grin]" src="images/icons/grin.gif" />


If you want something done right do it yourself two or three times!

LetsRodeo

1999 Isuzu Rodeo LS 4WD
3" CPL, 3" BL
LT265/75 16 TOYO Open Country AT
ShrockWorks Rock Sliders