1991 4Runner, the tube that atatches to the block for the oil dip stick is really loose to the point it will pull out.
My ideas are:

1. tap it lightly with a hammer to see if it will seat.

2. pull it out, flare the end a little bit, put some hi-temp gasket sealer on it and then tap it lightly with the hammer to see if it will seat.

3. purchase a new one and.... tap it in lightly (you get the idea)

anyone have any experience with this problem?

'87 4runner 37x12.50x15 MTRs
SAS, 4.88's, rear+front e-lockers
4x4Him --- Christian 'wheelin
4x4Him National Forum