First off, let me say that I really like how you're doing your buildup. It sounds like a truly balanced set-up, good components, light, reliable, and done right the first time. I'm in the middle of my 85 CJ-7 project as well, and disassembled the rig down to parts last summer.

As Dave said, make sure and hit as many bolts as possible with PB Blaster, as often as you can the week prior to disassembly. Also, buy some air tools if you haven't already. For the money spent, they are the best purchase I've ever made. Between the Blaster and the air tools, I didn't break a single bolt in the entire teardown.

Spend a lot of time labeling and bagging bolts and pieces, it's a pain when you're in the middle of it, but invaluable later down the line.

Removing the computer/wiring harness on the pass. side firewall can be a pain if you don't disassemble some of the heating assembly, but can be done without.

If you're going to run 33's and will need to re-gear anyway, look at buying a Scout II rear Dana 44 at the same time. You can pick them up for under $150 usually, they have the same bolt pattern, and are only a couple of inches wider than the stock widetrack AMC 20. All you'll have to do is move spring perches and shock mounts. Compared to buying the mandatory one piece shafts for the 20, or adding an axle truss, just buy the 44 and be done with it. 33's will be fine on the front Dana 30...it's really a pretty strong axle.

I was on the fence between powder coating and POR-15, but have since decided to do the POR. Mainly because I like the ability to grind/weld and touch up the frame, which just can't be done with powdercoating. Also, I've heard powdercoating won't show stress cracks in the frame very well, which is a common problem on CJ's around the motor and spring mounts. But if it's free, and you don't plan on modifying/welding too much in the future, I'd say powdercoating would be pretty ideal. See if your son can do something about the inside of the frame while he's at it...that would be nice.

Look into adding a clocking ring to your 300 when you add the trans; rotate that baby up and out of the way. If you want to rotate it all the way up to run a perfectly flat skid-plate (cool <img border="0" title="" alt="[Cool]" src="images/icons/cool.gif" /> ), you'll have to cut a pretty small patch in the floor, but once you line the tub, it'll look pretty unnoticable. Especially with 33's and only a few inches of lift, the Dana 300 will really soak up a lot of valuable clearance under your Jeep.

Anyway, keep us updated on the project, it sounds like it'll be really nice.


51 CJ-3a, 78 Cherokee Chief