|
|
|
|
Re: advice on cj7 frame-up rebuild
#275850
04/14/03 04:32 PM
|
|
Anonymous
Unregistered
|
As far as Ive seen POR 15 will not be effected by heat. I know folks who have had it for years on undersides of Jeeps and Street Rods and have seen NO sign of heat affetcing it.
The only weakness of POR15 is UV light. Thats why its only used for underbody. You can use it for a base coat/primer if you top coat it.
I plan on Using POR on my entire underbody Frame/tub Fenderwells and then as a base coat for interior of tub that will be covered with Speedliner for UV protection.
It gets expensive, at 95$ a gallon, not to mention the prep chemicals needed for proper application. But since I'm going the extra mile on my Restoration and putting some serious money into this project (been working on it for a year and will be another year min to be done) the cost of POR 15 doesnt bother me.
I want the Jeep tip top show condition as well as serious trail rig when im finished.
BTW anyone know where to get ready made dana 44's front and rear narrow track with solid axles and lockers? Id rather have them built and ready to go than hit junkyards and rebuild them.
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 5.386s Queries: 15 (5.383s) Memory: 0.6029 MB (Peak: 0.6359 MB) Data Comp: Off Server Time: 2026-11-18 13:49:07 UTCValid HTML 5 and Valid CSS