</font><blockquote><font size="1" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">quote:</font><hr /><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">Originally posted by randii:
<strong>"An 8-inch metal-cutting wheel in a circular saw would work well, too."</strong></font><hr /></blockquote><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">That's what I used to cut 1/4" thick 6061 aluminum. Aluminum is softer than steel, so it worked fine. Wasn't too difficult.

<small>[ March 10, 2003, 03:43 AM: Message edited by: Jeff the marmot ]</small>