Quote
#1 Is it necessary to remove the master cylinder from the truck in order to rebuild the unit?


Yes

Quote
#2 Do I need to mark the rod on the clutch pedal so that I can put it back it in the same place after reinstallation?


No

Quote
#3 Is there a bleeder valve, or some other way to bleed the line once itÆs back together?


Should be. My setup is different, so i can't tell you exactly, but it should be somewhere at the highest point on the lines.

Quote
#4 Are there any ôwhatever you do, donÆt do this!!!ö things that I need to know?


Not that i'm aware of, but i always used reman'd units rather than rebuilding them myself.

-Rob

Robert Gorrell
1995.5 Isuzu Rodeo - SAS'd and SOA'd, sitting on 38x13 TSLs, spooled D60 front, 14bff rear locked by detriot, high steer w/ hydro, dual Isuzu tcases.