Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
2.6 noise. Lifters? #288536 07/19/03 07:40 PM
Joined: Oct 2002
Posts: 205
tkal Offline OP
Wheeler
I got this noise. I am pretty sure it is coming from the top half of the motor. I believe it to be from the lifters. I have hydro lifters. The noise comes and goes. It is never there when I start the truck. Dedpening on how I drive it, it will start between 5-15 minuets in the drive. It will stop sometimes. Recently I have discovered that if I hold the rpm up around the 3-4k range with no load will get rid of the noise. Any ideas?


'88 D-50 2.6 needs some love.
Re: 2.6 noise. Lifters? [Re: tkal] #288537 07/20/03 01:37 AM
Joined: Oct 2002
Posts: 205
tkal Offline OP
Wheeler
Pages are too small.


'88 D-50 2.6 needs some love.
Re: 2.6 noise. Lifters? [Re: tkal] #288538 07/20/03 04:10 AM
Anonymous
Unregistered
Tkal:

Did you dis/reassemble the rocker arm shafts when you did the rebuild?

It is possible to put the shafts in backwards or upside down, or a combination of both...this will result in wear, noise, and ultimately fractured rocker arms after seizing agains the shafts under load.

Plugged up rocker shafts (sludge) can cause this problem as well. The shafts should be "flowed out" with parts washer solvent during rebuild to ensure no blockages exist, and the passages in the rocker arms should be flowed too.

I'd pull the rocker cover and compare what's set up there to what you find in the workshop manual, then pull the shaft assembly and reassemble (hint: use vaseline to hold your lifters in place when reassembling)...and I'd suggest you do it now rather than later to save some $$$.

Hope thin helps.

Rob in Hell

Re: 2.6 noise. Lifters? [Re: tkal] #288539 07/20/03 04:44 PM
Joined: Jan 2003
Posts: 1,741
powerRam50 Offline
Body Damage is Cool
) these dome hyd lifter seem to always nock i have a fairly new head and mine knock all the time i just ignore it till it fries but it hasent(darn it i want a non jet head but this thing just keeps going <img src="/forums/images/graemlins/angry.gif" alt="" />


87 dodge power ram 50,35" tires,5 1/2" total lift,4.6 gears,lockers front and rear,Rancho RS5000's,custom front bumper,custom rock sliders,cct extended diff breathers,75 amp alt(40 amp stock),thorely header,K&N,wheeled hard...
Re: 2.6 noise. Lifters? [Re: tkal] #288540 08/15/03 03:20 AM
Joined: Oct 2002
Posts: 205
tkal Offline OP
Wheeler
What do you all think? Someone at work suggested that the lifter is "smashed" Or more closely it cant keep up enough pressure to avoid the clicking noise. Which would explain why if I idel it, the noise will go a way. And it is louder the harder I drive it.

So my next question would be any ideas on how to locate exatly which one is making the noise? I do not have eight that I can toss in. I am planning on grabin one from my old head and using that.


'88 D-50 2.6 needs some love.
Re: 2.6 noise. Lifters? [Re: tkal] #288541 08/19/03 04:59 AM
Joined: Oct 2002
Posts: 205
tkal Offline OP
Wheeler
Bad lash adjuster is what I was trying to say. PowerRam50 This is not a little noise, not even a loud noise. I can hear ths noise at 2k rpm driving 55 mph That is with windows down and my loud tires.


'88 D-50 2.6 needs some love.
Re: 2.6 noise. Lifters? [Re: tkal] #288542 08/20/03 11:49 PM
Joined: Oct 2002
Posts: 205
tkal Offline OP
Wheeler
no one has anything else to say?


'88 D-50 2.6 needs some love.
Re: 2.6 noise. Lifters? [Re: tkal] #288543 08/21/03 04:56 AM
Joined: Jan 2000
Posts: 758
DanWheeler Offline
Rock Warrior
well if it doesn't happen at idle your going to have a hard time tracking down an individual lifter. See if you can find someone that will sit in the engine compartment with your hood off while you go 50 with a short section of hose. He can put one end to his ear and the other on the valve cover and move it around to see which lifter it is.


1986 Montero 2.6l
31X10.5 BFG MT - Weber carb with custom intake
Rear LSD - RCI seats - Oil cooler - Manual hubs
Custom bumpers front and rear + rock sliders







4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.019s Queries: 15 (0.014s) Memory: 0.6208 MB (Peak: 0.6993 MB) Data Comp: Off Server Time: 2026-11-17 13:49:02 UTC
Valid HTML 5 and Valid CSS