Tkal:

Did you dis/reassemble the rocker arm shafts when you did the rebuild?

It is possible to put the shafts in backwards or upside down, or a combination of both...this will result in wear, noise, and ultimately fractured rocker arms after seizing agains the shafts under load.

Plugged up rocker shafts (sludge) can cause this problem as well. The shafts should be "flowed out" with parts washer solvent during rebuild to ensure no blockages exist, and the passages in the rocker arms should be flowed too.

I'd pull the rocker cover and compare what's set up there to what you find in the workshop manual, then pull the shaft assembly and reassemble (hint: use vaseline to hold your lifters in place when reassembling)...and I'd suggest you do it now rather than later to save some $$$.

Hope thin helps.

Rob in Hell