Just got done getting my r&p installed. Love the power. I can actually pull hills in 5th under 2k rpm.

Problems:
The inner pinion bearing on the stock gearset is smaller in outer diameter than the bearing I got with my 5.38 dana gearset. Luckily the stock one showed almost no wear so we stuck it back in there.

Also decided to ditch the ABS ring rather than trying to modify the new carrier to make it work.

Overall, it went well. I'm anxious to get it out on the interstate to see what my rpm's are like with the 33's, but I have to get a few more miles on it first.

Front axle should be ready to pick up tuesday.

-chris

Last edited by rodeo_chris; 07/27/03 04:53 PM.

94 Rodeo, 35's, 5.38's, locked F&R, Rocker bar on one side, other side in garage

96 Tacoma, DD, pre-dented