</font><blockquote><font size="1" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">quote:</font><hr /><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">Originally posted by Poor A$$ Stock '93:
[QB]I would normally not have any problem w/ cutting but on my 93 the boots mount nice and neat into the carpeting and don't have that nice plactic console thingy to hide everything like the late 80's trucks did. My mechanic just told me to cut and weld the shifter handle so that it clears better but I am not too sure about that. I am thinking of just hacking whatever I have to to the shifter plate and then just getting a small piece of diamond plate (like 1' by 1.5') to cover it all up nicely. The short throw would still be nice though. I wish that it was possible to make one that didn't stick above the tranny so that it would work w/o a lift.[QB]</font><hr /></blockquote><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">Marlin makes one that works this way. Only the center section is raised but the two outer edges are stock height so it works w/o body lift.