to test a standard 12v bosch type relay, you need a voltmeter. ( i used a digital one so...).

you need to test whether the coil is okay.

connect the 2 posts of the coil and see if there's continuity.

if there is, then check whether the armature moves or not. applying voltage to the coil and see if the armature goes NO or NC...

finally, check all the grounds on the vehicle. that might mean checking the factory shop manual where the grounds are...


leo d.

90 4runner, v6, auto, WCOR CitB kit,
marlin duals, arb rear, tt front
4.88, blah, blah, blah...

Pres. of TEAM IFS! and
GETTING OFF 4WD Club member