94 rodeo, 3.2, 5spd, 50k miles on clutch.

While wheeling this past weekend, I had my truck bail out on me. I would be cruising along in 4lo, either 1st or 2nd gear and then all of a sudden the truck would just stop forward progress completely. There would be that funky clutch slippage smell. I'd pop it in reverse, back up some, put it back in 1st and it would barely move forward. After a few tries it would eventually pull itself.

The first time I was on a 15-20% grade, nothing major. Later that night I removed my shifter boot because I thought the boot was pushing the t-case into that neutral region between 4lo and 4hi. Next day everything was going fine, but it happened once again. This time on less of a grade. I had just finished climbing a nasty hill, so I didn't want to back down it.

I packed it up after that, thinking it was definitely the clutch. Got back to camp, hooked my trailer up and headed home. No slippage in 2wd even with the trailer in tow. Looking back I wish I had thought to stick it in 2hi or 4hi to see if the problem was still there.

BTW - I know I wasn't just spinning because I was watching both my tires on the driverside and my truck is locked front and rear. The second time I was also looked down to see the front driveshaft was not turning.

Now for the question: For those of you who know the ins and outs of the isuzu t-cases, is there any linkages or known problems that I should look for? My rodeo is 150 miles away from me right now, so tearing it apart will be a ways away, but I'd like to know what I'll be getting into.

TIA

-chris


94 Rodeo, 35's, 5.38's, locked F&R, Rocker bar on one side, other side in garage

96 Tacoma, DD, pre-dented