Bottom line? If it is the tranny, just find a good used one. Rebuilding or paying for someone to rebuild is an expensive route. Parts are expensive and there are several special tools needed. While there are people who rebuild trannys, finding one who is familiar with Isuzu boxes will prove to be almost impossible.

Now, let's figure out what is wrong. Fluid levels? What are they? Fluid condition and type? Might as well drain it and check the drain plugs. Clutch master and slave conditions? Fluid levels in each? Rear main condition?

There are not many things that could go wrong and still give you 2wd. RobG welded his 4wd gear to the mainshaft via the needle bearings because of massive fluid loss from the transfer case. That stopped things cold. If it was gear related, I would suspect you would have heard it before things got bad.

Other things to look at. Front drive shaft u-joints. If they are dry or dead they could bind enough to cause some issues (grasping for straws here). You say you are locked in the front. How? Lock-Right or Lincoln? Is it possible for the front end to have self-destructed?

That is a good place to start. You said you smelled clutch slippage, but you need to find out if that is the actual problem, or a result of a tranny issue.

Good Luck,
Michael