Now, let's figure out what is wrong. Fluid levels? What are they? Fluid condition and type? Might as well drain it and check the drain plugs. Clutch master and slave conditions? Fluid levels in each? Rear main condition?
I changed the fluid not too long ago, but I'll drain them both next time I go home.
There are not many things that could go wrong and still give you 2wd. RobG welded his 4wd gear to the mainshaft via the needle bearings because of massive fluid loss from the transfer case. That stopped things cold. If it was gear related, I would suspect you would have heard it before things got bad.
I also plan to pull the rear half of the t-case off when I get a chance to see if I can see anything obviously wrong in there. Probably wont get a chance until Christmas break.
Other things to look at. Front drive shaft u-joints. If they are dry or dead they could bind enough to cause some issues (grasping for straws here). You say you are locked in the front. How? Lock-Right or Lincoln? Is it possible for the front end to have self-destructed?
Front shaft looked ok, I'll double check. Lock-right in the front, No-Slip in the rear. Self-destructed front axle should have had more problems than what I'm experiencing. I just got my 5.38's put in there, they've got around 200 4wd miles on them.
That is a good place to start. You said you smelled clutch slippage, but you need to find out if that is the actual problem, or a result of a tranny issue.
I'll consider a new clutch, but due to a major lack of funds, as long as it seems to be pulling fine in 2wd, I can't justify the added expense right now.
-chris