I don't agree. A spring over can be done but as mentioned before, you have to be able to weld. There are several websites that will help you with the project. Also, you can incline your differential probably up to 45 degrees, but I would incle it a bit and have a CV driveshaft professinally fitted on the new assembly. THATS THE ONLY PROBLEM, your looking at a couple hundred bucks for that drivesahft. But if it isn't done, because of the incline, your drivesahft might not even turn. Then you would have to grind the crap out of the yoke and end up weakening and unbalancing your driveline. Thats a major NO NO. Here is an SOA site http://www.jeepaholics.com/tech/SOA/yjomesoa.htm.