I recently read on the Montero online manual (link posted by monty90), which allegedly is from Chilton's manual:

http://www.4x4wire.com/forums/showf...mp;amp;sb=5&o=14&fpart=1

http://www.e-toolbox.com/ads/rq.cfm

Quote
NOTE: When changing an aluminum or special type wheel rimmed tire, finger tighten the lug nuts first, then torque them to the proper value. DO NOT use an impact wrench to tighten the wheel nuts. DO NOT use oil on either the nut or stud threads.


I don't know why this would only apply to "aluminum or special type wheel rimmed tire". I'm assuming this is to prevent potential loosening of lug nuts?

Penetrating oil:
I need to pick up some of that PB Blaster I guess (Auto Zone?) - never seen it before. I always used WD40 or Liquid Wrench, which are both ok for temporary lubing - they both seem to evaporate relatively quickly though (I also spray it on tools ocassionally to fight rust).

Anti-seize:
I've had a small can of fel-pro that I obtained from a friend at an oil refinery, and it works great. I use it on all the previously posted locations, as well as exhaust flange and manifold bolts. Hopefully I'll be able to find another can when I run out !