Arc welding question

Print Thread

Rate Thread

Re: Arc welding question #39259 07/31/02 07:49 PM

Joined: Dec 2000

Posts: 154

Colorado Springs, Co, USA

Kendall

Wheeler

That is what I did, except with a chop saw. The problem was I only needed a little bend around 6 degrees. I ended up with a little too much material removed and had a gap at the proper angle. It did come out good, nice and clean look that way.

88 Xtra Cab, SAS, 35X12.50 MTR, Toyota E-Lockers front and rear, Rear seat, custom nerfs and rear bumper.

Entire Thread
Subject	Posted By	Posted
Arc welding question	Kendall	07/29/02 08:37 PM
Re: Arc welding question	Red_Chili	07/29/02 08:43 PM
Re: Arc welding question	4Crawler	07/29/02 09:54 PM
Re: Arc welding question	Anonymous	07/29/02 10:08 PM
Re: Arc welding question	Dandeman	07/29/02 10:46 PM
Re: Arc welding question	Anonymous	07/29/02 11:40 PM
Re: Arc welding question	Anonymous	07/30/02 12:33 AM
Re: Arc welding question	4Crawler	07/30/02 01:18 AM
Re: Arc welding question	Kendall	07/30/02 03:17 PM
Re: Arc welding question	4Crawler	07/30/02 03:58 PM
Re: Arc welding question	carter	07/30/02 04:22 PM
Re: Arc welding question	4Crawler	07/30/02 04:36 PM
Re: Arc welding question	Dandeman	07/31/02 02:56 PM
Re: Arc welding question	Kendall	07/31/02 03:05 PM
Re: Arc welding question	gota87toy	07/31/02 04:38 PM
Re: Arc welding question	Kendall	07/31/02 07:49 PM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social: