Well, driving with locked hubs in 2WD will only turn the front drivetrain, it won't be driven. So, yes it will wear on your front drivetrain, but much less than if you were in in 4WD.

Quote
Do the diff and drive shaft do the power transfer while the inner shaft gives structural support?

I'm not quite sure what you mean by inner shaft? In 4WD, power is transfered from transmission to the front driveshaft via the transfer case. The front driveshaft will turn the differential which then turns the front driveshafts and wheels.

Quote
Is it possible to explain to a novice why 4WD on dry pavement is so bad?

4WD on dry pavement isn't necessarily bad, it's just not good. <img src="/forums/images/graemlins/smile.gif" alt="" />
Think of it like this: Your driveshafts, front and rear, are essentially like two axles when in 4WD, except with no differential in between them - it's just a straight drive. Since there is no differential in the middle of these two, there is an extra strain put on them as the vehicle goes through turns. You will feel this as a "skipping" or "rubbing" when cornering at lower speeds. It makes turning more difficult for you and the truck. When off-road, there are things like gravel, dirt, and water that allow the drivetrain to "slip" at the wheels and releive the strain on the it.