It helps if you look at the tracks of all 4 wheels in mud or snow as the truck is turned. All 4 wheels travel a different distance, and the previous post says, there are diffs between the wheels on each end, but no center diff to allow different speeds between fore and aft, so you get tire scrub and strain on all the driveline components - the truck feels like it's tightening up as you turn harder, especially on hard pavement. A fair analogy is a tracked vehicle (tank/bulldozer) which has a constant track speed at all points, while distance travelled varies, so in any turn some portion of the track is skidding instead of tracking the surface.

Short take on how 4wd works:

Tranny output shaft splined to t/case input shaft, which spins a synchomeshed gear set for the low range reduction, shifted by a sliding shaft mounted fork on the synchor ring, which selects gear range (connected to 4WD shifter lever), and an additional likewise shifted dog clutch engages/disengages the chain sprocket that drives the fwd t/case output shaft. These two controls give you the ability to shift from high range to low range, and v.v., and from 2wd (driven chain sprocket disengaged) to 4wd (dcs engaged and front output shaft driven), and from h range (input shaft locked to output shaft in t/case) to lo range (input shaft locked to reduction gear train reducing output shaft speed). Most monties had auto hubs stock, which lock when the c/v shaft is driven in either direction, and unlock when 4wd is disengaged and the truck driven about 10-12' in the direction opposite that which last driven when 4wd engaged (I can hear an audible click in mine when they release. My a/t must be in neutral (not Park, that puts the driveline in a bind and you can't shift it), at slow idle, ebrake disengaged(usually), foot brake disengaged (usually), to shift into 4wd. Shift into lo range is easier, but can't be moving. Have to let the front tires get about 1-2 revolutions to lock the hubs, so go easy on the throttle until they lock.

Last edited by fasteddy; 02/14/04 12:51 AM.

Not responsible for advice not taken...