first you have to remove the front of the dash.

Remove these screws
http://berisford.net/uploads/Troopuh/dashr.jpg
Pull the dash front off and unhook all the electrical connectors. You should be able to take the front completley off.
Now you should be able to acess the gauge pod.
I am not 100% sure on this but I believe there is a screw on each side of the pod and 2 underneeth that are acessable between the steering column and the underside of the dash. Tilt the steering column down and use a very short screw driver or a very long one that has a handle that can reach past the column.

Now pull the gauges out and unhook the 2 ribbon cords in the back. They dont have locking connectors so you can just pull them out the back.

Now your gauges should be completly out.