Quote
If you have the right access to the machinery and/or friends, this option could turn out to be the cheapest way to go though.


Option #2 is to use the milling machine and lathe that my engineering department owns to make some 6 to 8 lug wheel adapters. I found them online from a link on Pirate, but they were over $100 each. I could probably locate some 8 lug steel wheels for cheap/free. I'll figure something out.

Rob - I picked up my new master cylinder today. Tried to use the part number in that picture on your website, but was told it is an obsolete number. The one I got isn't the plastic reservoir like yours, but the cast iron one. I'm trying to get the fittings worked out, but hit a dead end at the local Napa store today. Still doing my homework, so lots of searching left for me.

-chris


94 Rodeo, 35's, 5.38's, locked F&R, Rocker bar on one side, other side in garage

96 Tacoma, DD, pre-dented