I usually get Shell or Mobil gas... Last time I filled up it was Shell and I put in 89. I've been using the same service station for a while and haven't had any problems - they do a lot of business so I know they go through a lot of gas.

With the scan tool I can see the long/short term Fuel Trim Status (among other things)...

The data I have handy is from Friday, after I replaced the parts. Both long & short term fuel trim for Bank 1 report 0.0%. (I wasn't sure what that meant). The engine was cold (55.4deg), ~1400 RPM idle. Calculated load was 15.7%, intake manifold pressure was 8.7 psi. Fuel System 2 status is Open Loop (says it hasn't met conditions to go closed loop).

I had thought it might be a clogged injector... I was thinking of dumping a can of injector cleaner in since that is cheap & easy.

I'll read the Haynes manual and see what it says about checking the fuel pressure again... If I remember correctly, one of the fuel systems is under 50-60lbs of pressure at all times, but I can't remember which.

Do you know if there is a way to isolate the injector? Sort of see how it performs vs the injectors on other cylinders?

JW