</font><blockquote><font size="1" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">quote:</font><hr /><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">Originally posted by toyrker:
<strong>No. I haven't called yet. Its long distance & 230 miles away. I just thought someone would know the specs. I have not got a clue. If its 8", do you think it would be adaptable to my application? Is it heavy duty like the 6cyl diffs? Or is the 1 ton bit in springs ? Thanks!</strong></font><hr /></blockquote><font size="2" face="Verdana, Tahoma, Arial, Helv, Helvetica, Sans">For '85, the 1 ton axle was only available for the 4X2 on U.S. models. Foriegn models could get the 1 ton in 4X4. The difference between the two is that the spring perches are under the axle on the 4X2 and over the axle in the 4X4. The diffs on all 1 ton axles, should be the same 8" diff found in the 4x4. The diffs are the same 2 pinion. 4 pinion type diffs did not come out until '86, although anything is possible.

The 1 ton axle should be of the full floating type with permanant hubs in the rear. A very beefy set up. Personally, if your doing a build up and want to keep the rear the same width as the '85 and not use the longer '86 and newer 4x4 axles, it might be worth it to cut of the spring perches and weld them on top of the axle. Also, I'm not positive that the 1 ton had the spring under, it could have been a spring over as well, but I doubt it.

Also, if yours is an '85, it "might" be possible to just unbolt the full floating kit and just install that on your axle. I'm not quite sure how these are set up.

The available diff ratios for the 1 ton in '85, were 3.90, 4.10 and 4.30.

Good luck.


[color:"blue"]My Toyota/Expedition Website[/color]
Foreign & Military Toyotas - Expedition 4x4s
Our historical explorations & much more