I dropped off my truck to have the crossover steering installed earlier this week. I removed the front driveshaft before I took it up there. After looking at the shaft more closely it looks like at some point the factory '85 driveshaft has been replaced with one from an '86. I have done the searches here and see that the later shafts don't have as much flex in the cv joint. I saw the article about modifying them to increase movement, but before I do anything I want to check out my other options. The shaft will be going on a 1985 4Runner with the Marlin crossover steering. The front axle is moved forward ~2" with a hybrid set of Downey/stock rear springs. They will be mounted with a set of banana shackles that are 2" longer than stock. I also have a 2" drivetrain lift affecting the needed length of the shaft and only have a single xfer case. I have a second t-case and the crossmember is set up for a second case in the future, however it will likely be another year before I try to finish that. I have read the arguement back and forth about cv vs a u-joint at either end. I will need to drive the truck in four wheel drive at highway speeds. I can't find anything as far as cost of driveshafts.

I guess I would like to know if it would cost more to have a completely new shaft built or if lengthening and adding a longer slip joint to the one I have will be cheaper. All of the driveshaft places I have found have to have exact specs to give me a price. At this point I don't know what my specs are until I get the truck back with steering installed and I still need to get the shackles on there.

I apologize for the length of the post, but this whole driveshaft thing seems very confusing and I am frustrated that after all this I will have to go through it again when I go to dual cases.

Chris Sutton
Golden, Colorado


1985 Toyota 4Runner - Longfields, 5.29's, EZ Locker F/R, Marlin X-Over, Rancho 99012's, 35" BFG AT KO, 414K miles.
1996 FZJ80 stock with 191K miles.
1980 FJ40 stock with 85K original miles.