Yeah, I think Roger's number is about the going rate. Any shop should be able to measure it, if you want that added confidence.

At least you aren't looking at doing BOTH shafts with the crawl box. I am finding with a 3.4 V6 swap into an 87 I-4, the drivetrain MUST be moved ~3" forward. Gives me pause, on top of all the other work that would be involved. Heck, its only sweat, steel and green, how hard could it be? <img src="/forums/images/graemlins/rolleyes.gif" alt="" />

The new ORS location is a little obscure.
map lifted from his site
You can get there via Wadsworth, north from I-70 to 52nd, east to Marshall, thence north. The street takes a bit of a jog east, that would be 56th. Mebbe 3/4 block east of there, on the south side, he is in the southernmost space in the industrial building. Give him a call yet? He can tell you what their arrangements are, I just know what I did to get my shafts (direct the second time).

Good points on the crossover costs. A lot of folks claim an 85 is soooo much easier to build up than a SAS conversion, your costs give the lie to that approach if you want one that can crawl and is built hell for stout. Think about beefing the front spring hangers while you are at it. One advantage remains: the arch of the frame allows more up travel than a SAS, with less lift. Lemme tell ya, a welder more than pays for itself with these things.

I'd bet you'll be pleased when you are done.


-Bill
'87 4Runner w/ '96 5VZ-FE, 'Red Chili II'
'97 Taco XtraCab 3RZ-FE, 'BlackBean'
TLCA # 13257, Rising Sun 4x4 Club Land Use Coordinator
"He who stops being better stops being good." -Oliver Cromwell