Depending on the collapsed length and slip yoke travel, you may be able to make a good shaft now that will have enough stretch later for the dual cases.

I had spare shafts built for my 4Runner that will fit on either end of the truck, I built them for the collapsed length needed up front (about 33" as I recall), yet they extend enough to fit in back. I just had the shop fill what wasn't CV or u-joint with splines, I think it pulls out to about 48".

And its not the end of the world to have a shaft lengthened, it usually runs under $100. I had my front shaft lengthened 2 times in stock form, then had it converted to a long slip yoke when it was lengthened the last time when I moved my axle forward the last time.