I plan on installing my Supercharger one day next week since I am on vacation. The only thing I need now is the torque specs on the housing itself, and the tightening sequence. Anyone able to scan the oem manual for the intake plenum stuff for me ???

Any help would be greatly appreciated...

Thanks
Marc

Did you get it installed? Still need the torque numbers?

Yes, I still need them. I would really appreciate it if someone would post up the numbers and sequence....

Thanks
Marc

No sequence is specified.

Here's the '01 FSM text:
Install intake air connector assy (the lower part)
Install with a new gasket, 3 bolts, and two nuts
Torque: 18Nm, 13 ft.lbf
Install the DLC1 to the bracket (the diagnostic connector ? )
Install the ground strap to the intake air connector with the bolt.
Connect the fuel return hose.
Connect the vacuum sensing hose to the fuel pressure regulator.
Install the engine wire with the bolt.
Install air intake chamber assy (the top part)
Install with a new gasket, 4 bolts, and 2 nuts
Torque: 18Nm, 13 ft.lbf

I hope that's what you needed....

Thank you very much, I can now go about my endeavor. The fuel light is on, so I guess I better take out a loan and fill up the tank. This may me a bad time to have to use high octane fuel at almost $2.00 a gallon.

Marc in PA

you should be glad your not in southern cali,91 octane is almost 2.50!!!!
best of luck with the supercharger,thou.Its only a matter of time before i get one... <img src="/forums/images/graemlins/evil.gif" alt="" />
d

At the Sunoco in town

$1.67 for 87
$1.77 for 89
$1.87 for 91,92, or 93 I don't remember
$1.97 for 94

The best prices are at the Costco near where I work, It's like $1.76 for 92 Octane.

Give or take a few pennies on all of the prices...