The rear defroster is a series of resistors in parallel.
If you cut one (remove a parallel resistor), the total resistance goes UP.
I (total current) = Voltage /Resistance
As resistance goes up (and 12v remains constant), total current would go DOWN.

What you are concerned with is Power to defrost at a single point--a hotspot. What does cutting out one element do to the rest?
P = I * E = I^2 * R = etc.

This is a passive device--which an active device (such as an amplifier) I'd say it would burn out.

For a passive device, while TOTAL current current goes down, current in the individual remining those lines might go up slightly (need to simulate). So if you cut it down to one line, for example, it could get very hot and burn up the line. Or make a hot spot that cracks the glass on a cold day.

Plus tint would insulate slightly, holding the heat inside. I don't know for certain. I'll have to simulate.


[color:"white"]? 04 Rodeo DI ?[/color] 75k mi, body damage on the 1st weekend I got it.