Quote
Ya know, I kinda doubt one observation in that thread, that first gear is part of the shaft. Its pressed on. I don't know if it could be pressed off and a new one reliably pressed on though.


I don't think they are talking about 1st gear, they are talking about "THE" first gear on the input shaft. It is part of the input shaft, and I believe it has been welded on. The problem with this, is that this gear is different on the R151 and the R154. This gear drives the counter shaft. This caused a hole slew of problems, but still makes it possible. From what I have read, you get a terrible 1st gear because of all this.


It is better to make torque at high rpm than at low rpm, because you can take advtage of gearing.
----------------------------------------------------------------
www.supracharged.com
1994 4runner - SAS, 38 TSL's, Turbo 7MGTE swap, Turbo Tranny
Dual T-case, D44/D60 ront/rear