iv'e just got done doing a ground-up rebuild...but my engine is only firing off the number 1 and 3 cylinders...my 2 and 4 arent getting any spark at all. The wires are good, i checked them, and the plugs are good. I checked w/spare wires i had laying around. The rotor and cap are fine, although the cap has slight scuff marks from the rotor at the 2 and 4 contact points. The reluctor inside the dist. looks fine...maybe the pickup coil? How would I test that? Also, it couldnt be 180* out, because then i wouldnt even be able to turn over. Also, anyone know where the A.T. oil temp guage/sensor lives at on the vehicle? and it wouldnt happen to have a connector that looks like this? another view . any help would be great. thanks!