If you want some tube doors, you should be able to go to the junkyard and get the hinges off a similar vehicle. Then draw or have someone draw up some plans for the doors. You will probably need the door latch too. It will probably be easiest to make them out of square tubing. Then once you get a design, take it to a machine shop, buy the materials you need and have them fab it up. Im pretty sure machining and welding costs will be less than $100 and the steel will probably cost another $100. I might be able to draw up some plans for a set. But they will be for a 92 Rodeo since that is the only thing I can get the proper measurements for. If you get a good design you can probably sell it or partner up with a machine shop to build them and split the profits.

Dan


92 Rodeo, 3.1 TB crank, custom bumpstop spacers, DOR shackles, Flipped ball joints, D44 Rear, 4.56s and new magnaflow cat and dynomax ultraflow muffler Since been replaced by a 2 door Explorer on 31's shackles, cranked torsion bars and full exhaust