I've been getting check engine lights from code P1400 (OBDII) from the day I bought my truck two months ago. Some web surfing led me to the Manifold Differential Pressure Switch. I've reset the code several times now, and it shows back up within a couple hundred miles. After 5 or 6 times, I still have not been able to pick up a pattern as to what might be causing the switch to read out of range.

Last night I put a splitter & vacuum gauge at the port right by switch on the intake manifold. At idle, I had 18-20" Hg. Revving the engine using the throttle cable of course caused the vacuum to dip. If I revved hard enough, the gauge would shoot all the way back to 0". Is that normal? I used carb cleaner and light sprays of ether at various places around the manifold looking for vacuum leaks, but didn't find any. I confirmed a few weeks back that the lower plenum is the updated part number.

I figure that either the switch is intermittently shorting/malfunctioning, or something is causing it to drop out of range. I assume the switch reports lack of vacuum. I have never been of the part swapping mentality, and would like to know how to test the switch as well as what might cause the condition. Anyone have any ideas what to do next?

Thanks in advance,
Dave in KC

Last edited by davemtb; 06/22/04 05:37 PM.

Dave Smith
'96 SR - 31x10.5 Tires

"Facts are meaningless. You could use facts to prove anything that's even remotely true!" Homer Simpson