The primary purpose of the MDP sensor (as far Mitsubishi MFI) is to verify EGR operation (OBDII compliance). The only way to properly check it is to see what values it is showing under specific vacuum loads. However, i don't know what the resistace values would equal to at a specific vacuum amount. With a MutII scan tool, you can see what the MDP is "seeing" and compare it to an actual vacuum gauge hooked up the the intake. More than likely- the MDP sensor has an intermittant failure that is causing your problem. If your MDP vacuum values are low , you can try removing the MDP and cleaning out the small pin hole port that it's mounted to to eliminate any blockage from carbon and see if that helps.


Joel, CA