|
|
|
|
Re: wandering cj7
[Re: doc long]
#468518
06/26/04 12:38 AM
|
Joined: Mar 2004
Posts: 2,398
Body Damage is Cool
|
I believe bad U joints could contribute. You don't have to mess with the ball joints.Take the wheel and brake rotor off and you will see 8 (I think) 9/16 nuts. Take them off and the spindle might come off. I say might cause it might be rusted in place. when you get it out the axel will come right out assuming it's a stock D30. Changing the u joints is at least twice as hard as on a driveshaft cause all four bearing caps have to be pressed out. (Personally, I cut the old u joints out with a torch which makes the job a lot easier. Just got to be ready for when the O2 hits the grease! Instant flame thrower! <img src="/forums/images/graemlins/notooth.gif" alt="" /> Don't try this at home <img src="/forums/images/graemlins/shiner.gif" alt="" />) Oh yeah, be extra carful putting the axels back in. The tubes tend to be full of dirt.If you just shove them in its a good way to ruin your seals and cram some sand into the diff. I made a special tool to excavate the tubes before reassembly. You got to hold the end of the axel up so it doesn'tscrape the bottom of the tube.
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 3.878s Queries: 16 (3.875s) Memory: 0.6015 MB (Peak: 0.6345 MB) Data Comp: Off Server Time: 2026-11-16 10:24:14 UTCValid HTML 5 and Valid CSS