Did the job over the 4th weekend. The crankshaft pulley didn't give me any trouble. I built the tool referenced earlier in the thread on Alex's site. I snapped 1/4" bolts and went to 3/8". The torque spec was 150 ftlbs <img src="/forums/images/graemlins/shocked.gif" alt="" /> I also broke a lower cover bolt upon removal, so your tip would have saved me that time plus the fab time on the tool. A couple of hours at least.

Here's some additional thoughts to finish the thread. The job was pretty straight forward, but this was my first time replacing a timing belt. There was some trial and error. My knuckles left a trail of blood around the engine compartment <img src="/forums/images/graemlins/rolleyes.gif" alt="" />. Those cams were meatgrinders for sure. Once I figured out how to use wood shims and vice grips to lock the cams to each other and the belt in place, everything went good. To tension the timing belt, I used an awl in one of the pinholes, a deepwell socket on the center bolt, and a small prybar in between to tension the belt. I was pleased with how accessible all of the bolts were. I could see everything I needed to remove. The DOHC has an accessory mounting plate on the front that made the job quicker than removing a bunch of individual mounts and brackets. The ratcheting flat box wrenches were my main tool in the tight areas and worked great. I will be able to do it faster next time, but can't even comprehend how someone could do this job in 4 hours. Add replacing the water pump to the list of chores, and the job took me close to 15 hours <img src="/forums/images/graemlins/drunk.gif" alt="" /> Of course this was 3-4 hours on messing with the belt and the timing marks themselves, but also included numerous stops to blow up fireworks for my kids <img src="/forums/images/graemlins/smile.gif" alt="" />

Thanks to everyone for the help from this forum.

Dave in KC


Dave Smith
'96 SR - 31x10.5 Tires

"Facts are meaningless. You could use facts to prove anything that's even remotely true!" Homer Simpson