Frame rattle on 3rd gen

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Frame rattle on 3rd gen [Re: GreggieAtTheBat] #474400 07/10/04 11:35 PM

Anonymous

Unregistered

Check all the sway bar mounting points.

Check the exhaust system clearance all the way back. Pay special attension to the area at the cat and the frame cross member and where the pipe goes over the rear axle. If you have an aftermarket rear swaybar it may be clanking on the rear tail pipe flange and/or the pipe may be clanking on the rear axle trust link mount.

Gadget

www.GadgetOnline.com

Entire Thread
Subject	Posted By	Posted
Frame rattle on 3rd gen	GreggieAtTheBat	07/09/04 09:07 PM
Re: Frame rattle on 3rd gen	azrain	07/10/04 03:27 AM
Re: Frame rattle on 3rd gen	GreggieAtTheBat	07/12/04 05:58 PM
Add'l rattle source, perhaps	GreggieAtTheBat	07/12/04 10:20 PM
Re: Add'l rattle source, perhaps	FattyCBR	07/13/04 01:29 AM
Re: Add'l rattle source, perhaps	GreggieAtTheBat	07/13/04 05:29 PM
Re: Frame rattle on 3rd gen	Anonymous	07/10/04 08:33 PM
Re: Frame rattle on 3rd gen	Anonymous	07/10/04 11:35 PM
Re: Frame rattle on 3rd gen	Anonymous	07/11/04 09:04 AM
Re: Frame rattle on 3rd gen	Dandeman	07/11/04 02:46 PM
Re: Frame rattle on 3rd gen	Anonymous	07/14/04 02:33 AM
Re: Frame rattle on 3rd gen	GreggieAtTheBat	07/14/04 03:29 PM
Re: Frame rattle on 3rd gen	larsdennert	07/18/04 02:16 AM

Moderated by 4x4Wire, Adam F, Dandeman, kewlynx

Hop To

4x4Wire Social: