How I plumbed the stock LSPV out of my brake system

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: How I plumbed the stock LSPV out of my brake system [Re: Adam F] #475132 07/12/04 06:16 AM

Joined: Nov 1999

Posts: 863

Spring Hill, TN

DRM

Rock Warrior

How do you currently have the LSPV arm set up? Is it attached to the axle in the stock location, or have you added an edtender bracket to raise it up some, or do you have it toed up to the frame?

I would definately try adjusting the stock setup before I got into removing parts...

Also, make sure your rear brakes are properly adjusted.

David David's 4x4Spot.com

Entire Thread
Subject	Posted By	Posted
How I plumbed the stock LSPV out of my brake system	DRM	07/12/04 05:55 AM
Re: How I plumbed the stock LSPV out of my brake system	Adam F	07/12/04 06:13 AM
Re: How I plumbed the stock LSPV out of my brake system	DRM	07/12/04 06:16 AM
Re: How I plumbed the stock LSPV out of my brake system	4Crawler	07/12/04 06:42 AM
Re: How I plumbed the stock LSPV out of my brake system	Adam F	07/12/04 02:24 PM
Re: How I plumbed the stock LSPV out of my brake system	4Crawler	07/12/04 04:26 PM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 4.059s Queries: 16 (4.056s) Memory: 0.6021 MB (Peak: 0.6351 MB) Data Comp: Off Server Time: 2026-11-02 00:58:17 UTC
Valid HTML 5 and Valid CSS