Hey guys and gals, havent been here for a LONG time. Currently I am doing a internship at Bobcat. The trooper is going through a huge transformation, and I am spending all of my time and money on it. What am I doing to it you might ask? Well I cut everything off the front frame rails. I constructed a subframe for the lower sus arms. The lowers will only be roughly 5 inches apart, so darn near center mounted. The upper arms start above the headers. When its all over I should have around 22 inches of travel in the front, plus it should sit just a little over stock hieght anywhoooooo.

I want to brace the front spindels, (its not 4wheel drive anymore}, I was wondering if anybody has ever welded on the spindels, did it require nickel rod? How did it turn out.

One more question, and I know this has been covered before but I dont think we came to a conclusion. I want to make a fiberglass shell for the front fenders in the style of a pre-runner/desert racer. Has anyone worked with fiberglass? Is there a website that has info and or products that would be acceptible for a vehicular applications. Any info on fiberglass would be helpful, cause I know nothing.

Thanks again
Brady