Quote
I need to know about flaring hard lines to accept a brake line for the dana 44... I have the stainless lines, but I am not sure what fittings to use and what size flare I need to use... Thanks ahead of time... <img src="/forums/images/graemlins/patriot.gif" alt="" />


Sorry I didn't get back to you sooner...

I didn't flare a single line in my entire setup. I used nothing but compression fittings to factory flares from NAPA. Cut off the stock line at the rail, bolt on a compression fitting, bolt on the stainless line to that (now) SAE fitting. I'm not sure there are any more stock Isuzu flares left on my truck anywhere now that I've had the rear axle redone, too.