Quote
With your guys help I have narrowed it down to four fittings -

3 AN to 3/8-24 Fem. I.F.*
3 AN to 3/8-24 Fem.
4 to 3/8-24 Fem.
4 to 3/8-24 Fem. I.F.*

Do i need the "I.F." ones? Also is the stock hard line a 3AN or a 4?


Check this page:
http://www.4x4wire.com/isuzu/tech/SOA/SOAbrakes.html

These are the Earl's part numbers I used for my rear brake lines. The conversion fitting at the top that attaches to the factory hard line should be the same as you'd need for the front hard lines. It's Earl's part #640603.

To answer your question, the factory hard line fitting is a male, flared fitting (as are all hard-line, flared tube ends). To adapt something to it, you need a female, inverted flared fitting to match. These are metric, but from what I found, there's only really 1 "metric" size fitting that seems to work for Isuzu, Honda, Toyota, etc.

Stick with AN3 fittings. That's the apropriate size for brake lines.


FWIW, I'm using a stock brake line hose from an early toyota truck rear axle. It's the long line that drops from the frame down to the axle tube. It's male on 1 end, female on the other so it works as an extension (vs the Isuzu hose that is attached directly to the tee on the axle and cannot be used as an extension). It's about 12" long and the flares/threads are compatible with Isuzu. I'm using 1 on each side on the front as an extension.

--Dan

Last edited by houlster; 08/30/04 04:50 PM.