Quote
just a question. what happens if the lines aren't double flared? I know it is illegal and all, but what is so good about the double flare vs just flared?


Double flares are much more durable and handle higher pressures. Single flares are fine for fuel lines and such, but for a couple thousand PSI for brakes, the double is much better to use.

I've had very good luck double flaring tubing using a cheap Harbor Freight ($15?) double flaring tool. After a few tries to figure it out, they come out perfect every time. The key is preparing the tube. The cut has to be square to the tube. Not angled cuts. And the end has to be deburred, both inside and out.

If you're doing a double flare, you also want to make the outside edge of the cut very smooth and rounded, or slightly chamfered. The first step of the double flare is to bubble the tube. The end of the tube needs to fold inward, with the outward edge of the tube being directed in by the die. If it's got a sharp edge on it, it'll catch and the tube will just push out of the clamp instead of sliding along the die and buckling.

Kinda hard to explain, but easy to see once you have the tool in front of you to do the flare. I've done several 3/16" brake lines and 3/8" for the power steering pressure line with no problems. I am using the coated, plain steel (common at Auto Zone, Checker, etc) lines and not stainless which I think is a much harder material to get to buckle in the first step.


--Dan